Question asked to Palen
Revised on Nov 17, 2026
↗How does the exemption in ADR 1.1.3.6 apply to the transport of dangerous goods?
ADR 1.1.3.6 provides a partial exemption for dangerous goods carried in packages when the quantity per transport unit stays within the applicable limit. It does not remove all ADR obligations, and it is not an exemption for carriage in tanks or in bulk. (ADR 1.1.3.6.2, Volume 1, page 9).
First check whether an applicable special provision, the limited-quantity rules or the excepted-quantity rules already exempt the goods. Special-provision exemptions apply only when the relevant provision is assigned in Table A, column (6), and its conditions are met. (ADR 1.1.3.4.1–1.1.3.4.3, Volume 1, page 9).
Goods exempted under the provisions specifically listed in 1.1.3.6.5—including qualifying limited and excepted quantities—are not counted in the 1.1.3.6 calculation. (ADR 1.1.3.6.5, Volume 1).
Find the goods’ transport category in Table A, column (15). The categories are 0, 1, 2, 3 and 4. (ADR 1.1.3.6.1, Volume 1, page 9).
When all counted goods belong to the same category, these limits apply:
| Transport category | Maximum total quantity per transport unit |
|---|---|
| 0 | 0: no quantity-based exemption |
| 1 | 20, subject to the exception below |
| 2 | 333 |
| 3 | 1,000 |
| 4 | Unlimited for this exemption calculation |
(ADR 1.1.3.6.3, table, Volume 1, pages 10–11).
Category 1 exception: UN 0081, 0082, 0084, 0241, 0331, 0332, 0482, 1005 and 1017 have a limit of 50 kg, rather than 20. (ADR 1.1.3.6.3, table note (a), Volume 1, page 11).
The figures are not universally kilograms: liquids are counted in litres; solids and liquefied, refrigerated liquefied or dissolved gases in net kilograms; compressed and adsorbed gases and chemicals under pressure by receptacle water capacity in litres. Articles generally use their mass excluding packaging, with specific rules for explosives and dangerous goods in machinery or equipment. (ADR 1.1.3.6.3, quantity definitions, Volume 1, page 11).
For goods in different transport categories, calculate:
Total = (category 1 quantity x 50) + (special category 1 quantity x 20) + (category 2 quantity x 3) + category 3 quantity.
The result must not exceed 1,000. “Special category 1” means the UN numbers covered by table note (a); category 4 adds no points. (ADR 1.1.3.6.3, note (a), and 1.1.3.6.4, Volume 1, page 11).
For example, 100 litres of category 2 liquid plus 600 litres of category 3 liquid gives (100 x 3) + 600 = 900, within the exemption threshold. (Calculation under ADR 1.1.3.6.3–1.1.3.6.4, Volume 1, page 11).
Main requirements waived: Chapter 5.3 placarding and orange plates, section 5.4.3 instructions in writing, the ADR driver-training certificate requirement, and most other Part 8 requirements, including Chapter 8.6 tunnel restrictions. Part 9 is also waived. (ADR 1.1.3.6.2, Volume 1, page 9).
Important requirements remain:
If the applicable quantity limit or mixed-load total is exceeded, the 1.1.3.6 exemption cannot be used. (ADR 1.1.3.6.2–1.1.3.6.4, Volume 1, pages 9–11).